5:2 Fluid Dynamics - Conservation of Mass, Bernoulli Examples
Overview
Derek Elsworth applies Bernoulli’s equation and conservation of mass to practical fluid-flow problems, including jetpack thrust, a 60 mph prone cyclist, Niagara Falls, and an angled water jet. The worked examples show how streamline velocity, pressure, elevation, and continuity combine to estimate forces, power, fall times, projectile height and range, and flow from a tank with a finite surface area.
Key takeaways
- Bernoulli’s equation is applied between points on a streamline, with pressure head, velocity head, and elevation head balancing when losses are neglected.
- For a freely falling water parcel from height H, Bernoulli gives speed sqrt(2gH), the same result as elementary free-fall mechanics.
- At 60 mph, a crude 1 m² cyclist frontal-area model predicts roughly 15 kW of drag power; reducing the effective area to 0.1 m² lowers the estimate to about 1.5 kW.
- An angled jet from a tank of depth H reaches a maximum rise H sin²(theta), because only the vertical component of its outlet velocity is converted into elevation.
- For the ideal angled jet returning to its outlet elevation, the horizontal range is 2H sin(2 theta), derived from constant horizontal velocity and symmetric flight.
- The large-reservoir approximation fails when the tank surface velocity is significant; combining V1A1 = V2A2 with Bernoulli then resolves the outlet flow.
Chapters
- The opening compares kayak descents, including Jesse Sharp’s ill-fated Niagara Falls attempt, with water-jet and jetpack applications.
- A jetpack produces thrust by burning fuel with air, unlike a JetLev system that pumps water through an umbilical.
- Because air is roughly 1,000 times less dense than water, an air-powered system needs much higher exhaust velocity to generate comparable lifting force.
- Derek Elsworth clarifies that force multiplied by velocity is power, not work.
- Work is force times displacement and is measured in joules; power is work per second and is measured in watts.
- For the JetLev calculation, multiplying the supporting force by the jet velocity estimates the power needed to operate the system.
- Along a streamline, Bernoulli balances pressure head, velocity head, and elevation head between upstream and downstream points.
- The stated assumptions are inviscid, irrotational, incompressible, steady flow; Elsworth notes that the equation is also applied approximately to gases.
- Continuity equates incoming and outgoing volume or mass flow rates, allowing velocities to be related when Bernoulli leaves two unknowns.
- The analysis makes the flow steady by viewing the cyclist from a frame attached to the bicycle, like a stationary bike in a wind tunnel.
- Bernoulli converts the upstream air velocity into stagnation pressure at the cyclist’s front, giving pressure approximately equal to air density times velocity squared divided by two.
- At 60 mph, or about 30 m/s, and an assumed 1 m² frontal area, the rough estimate is about 0.5 kN of force and 15 kW of power.
- A tapered effective area near 0.1 m² reduces the estimate to about 1.5 kW, closer to a person’s approximate maximum output of 0.5 to 1 kW.
- For a water parcel falling from the lip of Niagara Falls, the free surface and the parcel’s path are both at atmospheric pressure.
- Starting with negligible speed at the lip, Bernoulli gives the impact speed as the square root of two times gravity times the vertical drop.
- The calculated velocity follows the streamline: it is downward for a free fall and points along the slope for water flowing down a ramp.
- Differentiating the Bernoulli-derived free-fall velocity with respect to position yields vertical acceleration equal to gravity.
- For a drop of about 40 m, the kinematic relation gives a fall time of roughly 2.9 seconds.
- That estimate is consistent with the reported descent time of about three seconds, assuming air resistance is neglected.
- A bucket with water depth H sends a jet from its bottom at angle theta; the goal is to find the jet’s maximum height and horizontal range.
- With the outlet as the elevation datum, the large-tank approximation makes the free-surface velocity negligible.
- The jet exits into the atmosphere, so atmospheric pressure cancels between the tank surface and the free jet.
- For a vertically directed jet, Bernoulli predicts that the water rises to the tank’s free-surface height H before its vertical velocity reaches zero.
- At an angle theta, the outlet speed is the square root of 2gH, and its horizontal component remains constant during flight.
- Comparing the outlet and apex with Bernoulli gives a rise of h = H(1 − cos² theta), or H sin² theta.
- At the apex, the vertical velocity is zero while the horizontal velocity remains the outlet speed multiplied by cos theta.
- Using the apex height h = H sin² theta, the time to fall back to outlet level is the square root of 2h/g.
- The trajectory is symmetric, so the full range is twice the horizontal distance from the apex, yielding L = 2H sin(2 theta).
- For a free jet from a large reservoir, the surface velocity is approximated as zero and Bernoulli gives outlet speed as the square root of 2gH.
- The same speed relation applies whether the jet initially points upward, horizontally, or downward, with velocity interpreted along the streamline.
- If the reservoir cross-section is not large compared with the outlet, the surface velocity can no longer be discarded.
- For finite tank area A1 and outlet area A2, conservation of volume gives V1A1 = V2A2.
- When water is continuously added to keep the level at H, the tank surface must move downward at a finite velocity as water exits.
- Substituting the continuity relation into Bernoulli eliminates one of the two unknown velocities and allows the outlet speed and flow rate to be calculated.
Transcript excerpt
0:05 fine oh you can't see turned off automatically fine that's why you couldn't see [Music] not so different from the jet Lev maybe but a bit less controlled perhaps and maybe more juvenile I suppose as well so anyway so interesting things to
0:53 get and a whole host of the other jackass movies no doubt are they still in Vogue I haven't looked at the for an age uh we looked at this last time um uh the world land the prone land speed record and maybe we'll start off doing that um and talk about that we talked about Air France oh yeah let's have yeah I don't know it's another captain and I thought this was someone else but apparently someone another person actually did this but you'll see in a minute uh remember working up in Southern Ontario in 1990 uh when a guy
1:44 kayaked off Niagara Falls and so this is apparently a Falls in in Brazil the to the basement by a kayak Pedro Olivia R his boat a record 127 to the bottom of the and amazingly survived without a scratch the drop took exactly seconds it breaks the old record by about 20t while it looks like they might have just chucked D over the falls the movie theug The and his friend appeared on the show to verify the story then the prome stue into the I that's a joke I guess right so yeah fine so survived so the what I thought it was was a guy called Jesse sharp kayaking off um Niagara Falls and so this they found his boat but they didn't find him
2:35 uh niagar Falls is about the same height I think it's 100 100 plus feet 40 or so meters beaten up tip of a boat looks
This is the start of the transcript. Save this video free for the whole transcript, searchable and time-coded.
In this course
Related notes
Summary, takeaways, and chapters were generated by AI from the video's transcript and may contain errors. The video belongs to its creator, Derek Elsworth.