Calculus II ep24: The Alternating Series Test (Nov 9, 2026)
Overview
Prof. Staecker reviews the limit comparison test, using dominant terms to compare complicated positive series with harmonic, p-series, and geometric series, then introduces the alternating series test. The lecture gives the test’s two conditions, explains convergence through partial sums that oscillate in shrinking steps, and applies it to the alternating harmonic series and an alternating series with powers of two.
Key takeaways
- For positive-term series, a finite positive limit of a_n/b_n guarantees that Σa_n and Σb_n share convergence behavior.
- Dominant-term comparisons reduce complicated expressions to familiar benchmarks: polynomial degrees yield p-series, while exponential terms yield geometric series.
- The alternating series test proves convergence when the unsigned magnitudes b_n decrease and approach zero.
- Alternating-series convergence can be understood through partial sums that move back and forth by progressively smaller amounts.
- For Σ(-1)^(n+1)/n, the magnitude sequence 1/n decreases to zero, so the alternating harmonic series converges even though its terms change sign.
- When proving a magnitude sequence decreases, translate b_(n+1)≤b_n into an inequality and simplify; for 1/2^(n−1), this reduces to comparing adjacent powers of two.
Chapters
- For positive sequences a_n and b_n, if lim(a_n/b_n) exists and is greater than zero, their series either both converge or both diverge.
- The limit comparison test is useful when a complicated term resembles a simpler benchmark series.
- The comparison establishes matching convergence behavior, not equal sums.
- Set a_n = 1/(n+3) and b_n = 1/n, since the shifted denominator has the same leading behavior as n.
- Compute a_n/b_n = n/(n+3), whose limit is 1, satisfying the test’s positive-limit condition.
- Because the harmonic series Σ1/n diverges, Σ1/(n+3) also diverges; a direct smaller-than comparison would not establish this.
- For the example with numerator 3n+7 and denominator √(n⁴+constant), the dominant terms are 3n and √(n⁴)=n².
- Choose the benchmark 3/n; the ratio of the original term to 3/n tends to 1.
- The benchmark is a constant multiple of the harmonic term, so it diverges and the original series diverges as well.
- A positive constant factor such as 3 may be included in the benchmark without changing its convergence.
- For 3ⁿ/(2ⁿ+n), the exponential term 2ⁿ dominates the polynomial term n in the denominator.
- Compare with 3ⁿ/2ⁿ; the ratio of the terms tends to 1, using L’Hôpital’s rule twice or equivalent dominant-term reasoning.
- Rewrite the benchmark as (3/2)ⁿ, a geometric series with ratio greater than 1, so both series diverge.
- Students work through two limit-comparison problems before the solutions are discussed.
- The later solutions identify leading polynomial degrees and exponential terms as the main clues for selecting each benchmark.
- The examples reinforce that the comparison series should be recognizable as a p-series or geometric series.
- For (5n+n⁴)/(n⁷+n⁵), compare dominant terms n⁴/n⁷ with 1/n³; the ratio tends to 1.
- Since 1/n³ is a p-series with p=3>1, it converges, and the original series converges.
- For (n+2ⁿ)/5ⁿ, compare with 2ⁿ/5ⁿ; the ratio tends to 1.
- The benchmark (2/5)ⁿ is geometric with ratio 2/5<1, so the original series converges.
- The integral test requires decreasing terms, while the comparison tests discussed require positive terms.
- Alternating series switch signs from term to term, so the signed terms are not a positive sequence suitable for ordinary comparison.
- The alternating harmonic series, with terms 1, -1/2, 1/3, -1/4, and so on, motivates a dedicated convergence test.
- Write an alternating series as terms with alternating signs and positive magnitudes b_n, for example -b₁+b₂-b₃+… or the reverse sign pattern.
- The alternating series test requires b_(n+1)≤b_n for every n and lim b_n=0.
- When both conditions hold, the alternating series converges, whether it begins with a positive or negative term.
- For partial sums beginning B₁-B₂+B₃-…, each new term moves the sum left or right on the number line.
- Decreasing magnitudes ensure each new move is smaller than the preceding move, preventing the sums from overshooting by as much.
- Because b_n tends to zero, the back-and-forth steps shrink toward zero and the partial sums approach a limit.
- Separate the sign pattern from the magnitude sequence b_n, then check lim b_n=0 and verify that b_n is decreasing.
- The limit check is often direct, while proving monotonicity may require an inequality argument.
- The test proves convergence when both conditions hold; failure to verify either condition does not by itself prove divergence.
- Represent the positive-starting alternating harmonic series as Σ(-1)^(n+1)/n, with b_n=1/n.
- The magnitude limit is lim 1/n=0.
- To prove decrease, compare 1/(n+1)≤1/n; cross-multiplication reduces this to n≤n+1.
- Both conditions hold, so the alternating harmonic series converges.
- The final example starts with a positive term and uses denominators 1, 2, 4, 8, …, giving magnitudes 1/2^(n−1).
- Use (-1)^(n+1) to make the first term positive when the index starts at n=1.
- The shift n−1 in the exponent is needed because the first denominator is 2⁰=1.
- For b_n=1/2^(n−1), the limit is zero because the denominator grows exponentially as n increases.
- The required inequality b_(n+1)≤b_n becomes 1/2ⁿ≤1/2^(n−1).
- Cross-multiplication gives 2^(n−1)≤2ⁿ, true because the right side has one additional factor of 2.
- The magnitudes 1/2^(n−1) are decreasing and tend to zero.
- The alternating series test therefore proves convergence for the series with alternating signs and those powers-of-two denominators.
- The lecture closes by deferring further alternating-series examples to the next class.
Transcript excerpt
0:00 All right, great. Let's continue talking then about the comparison test. So last time we discussed what we usually call the comparison test, which is the thing about the biggers and the smallers. Um, at the very end, and I will refresh your memory, we started talking about the limit comparison test. the limit comparison test. And this is uh the thing about um a's and b's and the limit. I'll just write it out uh out again. It says if a n and bn are positive sequences for all n
0:50 and this limit exists and is greater than zero. So we call this C usually and so if this limit exists and that C is greater than zero it's automatically going to be positive because uh a the A ends and the bns are positive but actually it is possible this C equals zero and that that is not allowed in this what I'm about to say. So if this limit exists and is greater than zero then the two series a n and bn as series they have the same convergence meaning either they both converge or they both diverge.
1:42 They don't converge to the same thing but they mean [snorts] but I mean uh either they both converge or they both diverge. both converge or both diverge. All right. Uh so this is called the limit comparison test. The idea is uh is the same as the other comparison test. I mean the the basic structure of what you're going to do is the same as the other in that I will give you a sort of weird sequence and you look at that and say this one looks kind of like this other simple one. Um so usually I I'll give you like the A's and you come up
This is the start of the transcript. Save this video free for the whole transcript, searchable and time-coded.
In this course
Related notes
Summary, takeaways, and chapters were generated by AI from the video's transcript and may contain errors. The video belongs to its creator, Prof Staecker.